UnLatch Electronic Strike

U

NLATCH is for any application where an electric strike would be used for a cylindrical/tubular lockset. A single UNLATCH model will operate any North American cylindrical type spring latch and dead latch. There is no need to determine the specific brand of latching hardware, the UNLATCH accepts all of them. Similarly, the same UnLatch model can be installed on all door types: steel, aluminum or wood. Problems of ending up with the wrong electric strike model for the door or latch type are eliminated.

• Size: Standard ANSI 4-7/8" Strike.
• Dimensions: 3-3/8" Long, 1-3/8" wide, 1-7/16" Deep (86 x 35 x 36.5mm)
• Voltage: 12 & 24 VDC +20% -10%. Full wave rectified DC acceptable.
• Electric Motor: No Solenoids.Operating Temperature Range: -20 to 125 F
• Listings: UL R18923 and BP7041
• Stainless Steel Face with Metal Enclosure.
• Supplied with 10ft. Cable.
• Mounting fasteners included.
• Current Draw:
  (@ 12VDC) 40mA continuous, minimum 300mA when motor is operating.
  (@ 24 VDC) 40 mA continuous, minimum 200 mA when motor is operating.
  Higher capacity supply (1-3 Amps) is recommended for start-up inrush to achieve best operation under pre-load.

• No cutting on the jamb required
• Motorized, no solenoids

Fully concealed installationMaintains dead-latch function at all timesReleases under pre-load

• Latch status sensor is standard
• <